Western red cedar
Part of: 44091090 — Other: — Other
N213902 · 2012-05-15 — The tariff classification of a wooden hand rail, sub rail, and fence picket from Canada
The ruling was requested on a wooden hand rail, sub rail, and fence picket. Three representative samples, identified as “molded fluted hand rail”, “sub rail”, and “molded stockade picket” were submitted for our review. The “moulded fluted hand rail” is a 3 1/8” (w) x 1 3/8” thick, unfinished, continuously shaped, solid western red cedar board. The face of the rail is flat, and the edges are nosed. The back of the hand rail is shaped with a 1 ½” wide groove throughout its length. The ends are not worked. You state that the hand rail will be imported in various lengths measuring 4’ to 8’. The…
L80974 · 2004-12-17 — The tariff classification of cedar hot tub corners from Canada
, you requested a tariff classification ruling. The ruling was requested on western red cedar hot tub corners. A representative sample and pictures showing its application were submitted. The sample consists of a continuously shaped solid wood board measuring approximately 4-1/2” wide by 1-1/4” thick. One surface of the board is rounded with a convex shape. In addition, two equidistant V-grooves run lengthwise down the rounded surface. The edges of the board are beveled. The ends are cut flat and not further worked. The shaped wood board with the contoured surface is used as the corner piece…
J83544 · 2003-05-15 — The tariff classification of chamfered posts, beaded balusters and TimberStrand® LSL (laminated strand lumber) from Canada
The ruling was requested on chamfered posts, beaded balusters, TimberStrand® LSL and waste wood blocks. Representative samples of the chamfered posts and beaded balusters, descriptive literature of the TimberStrand® LSL and a video tape of the waste wood blocks were submitted. The chamfered posts consist of nominal 4” x 4” western red cedar boards with one chamfered end. The chamfered end has one inch of the four edges cut off at about a 45 degree angle. The posts will be imported in lengths of 4’, 6’ and 8’. In some cases, the posts will have additional saw grooves around the top of the post…
J81118 · 2003-03-09 — The tariff classification of cedar wood with rounded edges from Canada
, you resubmitted your request for a tariff classification ruling. The ruling was requested on a cedar wood product. Representative sample lengths of the product and additional information regarding its application were submitted. The samples consist of rectangular pieces of solid wood with two rounded edges and square unworked ends. The species of wood is western red cedar. The processing is described as running the wood through a molder to create “0.5 inch radius edges” along the entire length. The samples measure approximately 1-5/16” x 2-5/16” x 6” long. The product will be imported in…
I85923 · 2002-09-29 — The tariff classification of wooden boards with rounded edges, from Canada.
(Calgary, Alberta, Canada). The ruling was requested on certain wooden boards (western red cedar or pine) intended for use in the production of Adirondack chairs. A sample said to represent the product in its imported condition was submitted for our examination. It is a section of a solid wood board measuring approximately 1” thick by 5¼” wide. The corners of the two edges have been substantially and continuously rounded along their length. The ends are square-cut. The sample is only 7” long, but the actual imported boards will be in lengths of 2, 3 and 4 feet. The applicable subheading for…
Not sure this code fits your product? HaiLang AI determines the US HTS code from a description in about a minute.
Classify a product