Other articles of nickel:
Part of: 75 — Nickel and articles thereof
N299516 · 2018-08-24 — The tariff classification of wire rods/sticks from Switzerland
Samples, photographs, an inspection certificate including the chemical analysis for the rods/sticks and informational literature on usage were submitted for our review. The samples will be returned to you as you requested. You stated in your letter that you are requesting classification for “A prospective importation of alloy steel TIG wire rods from Switzerland.” The subject articles will measure approximately 1/8 inch in diameter and 3 inches in length. You indicated that “The rods are for use as welding consumables in TIG welding applications, such as welding reformer tubes. They are for…
H080821 · 2012-06-14 — Revocation of NY N058237, dated May 13, 2009; subheading 7508.90.50, HTSUS; tariff classification of a nickel bolt
The ruling classified the article under subheading 8414.90.41, HTSUS, which provides for “Air or vacuum pumps, air or other gas compressors and fans; ventilating or recycling hoods incorporating a fan, whether or not fitted with filters; parts thereof: Parts: Of compressors: Other: Other.” CBP has reviewed the tariff classification of the subject nickel bolt and has determined that the cited ruling is in error. Pursuant to section 625 (c)(1), Tariff Act of 1930 (19 U.S.C. 1625 (c)(1)), as amended by section 623 of Title VI, a notice was published in the Customs Bulletin, Vol. 45, No. 49, on…
959560 · 1997-02-11 — Nicke l Coated Carbon Fibers Covered With Polycarbonate Resin; Nickel Oxide Sinter Matte Thermally Deposited onto Carbon Fibers and Coated With Polycarbonate Resin; INCOSHIELD; Composite Good, GRI 3(b), Essential Character; Originating Goods, North American Free Trade Agreement (NAFTA), General Note 12(b)(ii)(A)
In a letter, dated July 31, 1996, you inquire as to the tariff classification and country of origin of a nickel-coated carbon fiber material to be used in frequency interference shielding. You provided additional information by telephone on February 5, 1997, and requested country of origin information both for marking purposes and for the purpose of determining eligibility under the North American Free Trade Agreement (NAFTA). As we advised, you will receive a separate country of origin marking ruling. FACTS: The merchandise in issue, designated INCOSHIELD, is a nickel-coated carbon graphite…
954144 · 1993-08-18 — Tie Rods; Reconsideration of PC 877340; "parts of general use"; section XV, note 2; section XVI, note 1(g); heading 7318; EN 73.18
, requesting reconsideration of PC 877340, dated September 11, 1992, concerning the classification of tie rods under the Harmonized Tariff Schedule of the United States (HTSUS). FACTS: The articles in question are tie rods, which are used exclusively with jet aircraft engines. Tie rods are structural rods which tie the compressor and turbine assemblies in an engine together. They may be internally or externally threaded on both ends or may have a head on one end. Tie rods resemble bolts but are produced from materials of greater tensile strength to withstand more rotational shear stress than…
087589 · 1990-10-16 — Aircraft Fasteners
Our ruling follows. FACTS: You maintain that all of your fasteners are dedicated to the aerospace industry because of the specialized requirements (tensile strength, fatigue, hardness, etc.) of that industry. Consequently, they should be classified free of duty in accordance with New York ruling 848823, dated February 8, 1990. This ruling held that hex head bolts of titanium and inconel (a nickel, chromium, and iron alloy) were classifiable free of duty in subheading 8803.30.0000, Harmonized Tariff Schedule of the United States Annotated (HTSUSA), other parts of airplanes. Specifically, you…
Not sure this code fits your product? HaiLang AI determines the US HTS code from a description in about a minute.
Classify a product