Ball or roller bearing type
Part of: 84833040 — Flange, take-up, cartridge and hanger units
g86860 · 2001-03-06 — The tariff classification of housed bearings from China.
The items in question are described as types of housed bearings, which include: - pillow blocks formed of either cast iron or pressed steel, incorporating ball bearings; - flanged housings in a range of configurations, e.g., round, oval, square, formed of either cast iron or pressed steel, incorporating ball bearings; - a disk harrow unit, which is a ball bearing housed in a square flanged unit of pressed steel with enhanced seals to seal against dust, dirt and water. You indicate that the housings may in some cases be presented separately, without a bearing. Descriptive literature and…
879575 · 1992-11-18 — The tariff classification of a ball bearing cartridge unitfrom Japan
The item at issue is a bearing cartridge used in the Integral series of 1.8 inch disk drives. The cartridge functions as the pivot in the actuator assembly of the drive. In use, the function of the cartridge is to allow the actuator to rotate through a limited angle of 39 degrees with minimal rotational friction, while restricting motion in all other directions. The cartridge consists of a housing, spacer and two miniature, instrument grade radial ball bearings. The bearings are bonded into the cartridge housing with the use of a high strength adhesive. The spacer is used for preloading the…
874636 · 1992-06-18 — The tariff classification of a steel flange bearing housingfrom Italy
The item in question, part number E-284487, is a flange bearing housing designed to incorporate a spherical roller bearing. The item is not imported with the bearing pre-mounted. The unit is used, in conjunction with a bearing, to support a rotating shaft on a plastic material granulator. As the photographs and other descriptive literature submitted with your inquiry show, the subject part contains a hollow cavity into which the spherical roller bearing is press-fitted, and an outer flange, with pre-drilled holes, for affixing the assembly to the side of the granulator The applicable…
862945 · 1991-06-03 — The tariff classification of an unmounted bearing flangehousing from Japan
The item in question is a circular steel flange used to house a ball bearing. It is designed to be incorporated into a hand-held, pneumatic, horizontal air grinder. When matched with its bearing, this stem supports the rotating arbor at the point where it joins the speed controller. There is a single alignment hole on the outer rim to secure the flange to other machine components. The applicable subheading for the mounting flange will be 8483.30.4040, Harmonized Tariff Schedule of the United States (HTS), which provides for bearing housings; flange, take-up, cartridge and hanger units, for…
Not sure this code fits your product? HaiLang AI determines the US HTS code from a description in about a minute.
Classify a product