Other
Part of: 853390 — Parts:
N066820 · 2009-07-06 — The tariff classification of a replacement dimmer knob from China
The merchandise subject to this ruling is a replacement dimmer knob. A photograph of the retail packaging identifies the knob as Item # 50804. This plastic knob is used for replacing broken or lost knobs on dimmer switches enabling the user to turn a light one and off and to adjust the brightness of a lighting fixture. The replacement dimmer knob will be imported with three universal adapters. The adapters enable the knob to be used on various sized dimmers, when matching one of the three adapters to the shaft of a given dimmer. The applicable subheading for a replacement dimmer knob (Item #…
N027495 · 2008-05-27 — The tariff classification of a Hand control without a sensor from an unspecified country.
The merchandise subject to this ruling is a hand control without sensor. It is identified in your letter as Part Number 132694 Assy. The subject item (Part Number 132694 Assy) is a hand control designed for use on large Caterpillar dump trucks as the control to raise/lower the bed (dumping portion). The hand control is assembled by Williams Controls, Inc. The end user mounts a rotary position sensor into the hand control. The sensor is a potentiometer, which, once inserted into the hand control, sends a signal through a wire harness directly the hydraulic valve control on the Caterpillar dump…
M83373 · 2006-06-05 — The tariff classification of parts for a throttle body and accelerator pedal sensor from Japan
The articles in question are described as a “wave washer”, part number C21X6-RCA-A010, a “knock pin”, part number CR6U0-RCA-0001, and a “lip seal”, part number CR6S1-RCA-0031. Descriptive information and samples were submitted. Based on the information you have submitted, the wave washer is a part used in a throttle body to keep a motor engaged into a gear and reduce vibration. The knock pin and sensor are parts of accelerator pedal sensor assembly. The knock pin is used as a mechanical contact point in the sensor assembly. The lip seal, which is comprised of a rubber ring within a structural…
I89953 · 2003-01-20 — The tariff classification of Accelerator Position Sensor Parts from Japan
(KIPT). Your request covered 12 items. However, ruling requests must be limited to a maximum of 5 items in order to be accepted. The items in a single request must be of the same class or kind. For example, a request concerning textile articles may not include items such as footwear. The outside of envelopes and packages should be annotated "Binding Ruling Request." This ruling will address the first 5 items listed within your request, which are the Gasket (Part Number CR640-RCA-0000), Seal (Part Number CR651-RCA-0000), and three Springs (Part Numbers CR622-RCA-6000, CR622-RCA-0000, and…
Not sure this code fits your product? HaiLang AI determines the US HTS code from a description in about a minute.
Classify a product