Not in coils
Part of: 72193500 — Not further worked than cold-rolled (cold-reduced): — Of a thickness of less than 0.5 mm
I84865 · 2002-08-25 — The tariff classification of stainless steel sheet from Sweden.
The product to be imported is Type 304 and Type 316 stainless steel cold-rolled quench annealed sheet measuring 2250 mm in length, 1000 mm in width and ranging from 0.4 mm to 0.8 mm in thickness. This flat-rolled sheet will ultimately be used in the manufacture of heat exchangers. This stainless steel sheet, in its imported condition, meets the definition for flat-rolled products in HTS Chapter 72 Note 1. (k): “Rolled products of solid rectangular (other than square) cross section…in the form of…straight lengths, which if of a thickness less than 4.75 mm are of a width measuring at least 10…
I81231 · 2002-05-16 — The tariff classification of stainless steel sheets from Taiwan.
The products to be imported are Type 304 stainless steel sheets made to ASTM Specifications A 240 and A 480. ASTM Spec A 240 is the Standard Specification for Heat-Resisting Chromium and Chromium–Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels. ASTM Spec A 480 is the Standard Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip. The products range from approximately 0.5 mm to 3 mm in thickness and measure either 48 inches or 60 inches in width. These sheets have either a No. 2B finish, which is a cold-rolled…
h84171 · 2001-08-09 — The tariff classification and country of origin of cold-rolled flat-rolled stainless steel produced from hot-rolled stainless steel coils from various countries, including France, Spain, Japan, Korea, Taiwan and South Africa.
You also ask about the country of origin of the product that is imported into the United States. The products to be imported are cold-rolled flat-rolled stainless steel products in coil and cut-to-length form. These flat-rolled products range from 50 mm to 1219 mm in width and from 0.25 mm to 2.0 mm in thickness. Some of the products will have a No. 2B or No. 2D unpolished cold-rolled finish and some will have a No. 3 or No. 4 polished finish. The applicable subheading for the cold-rolled flat-rolled stainless steel products measuring 600 mm or more in width and measuring over 1 mm but less…
089538 · 1991-08-07 — Classification and Country of Origin of cold-rolledstainless steel coil
FACTS: Type 304 hot-rolled stainless steel coils, manufactured in Canada, are sent to Korea where they are processed into cold- rolled steel coils. The cold-rolled steel coils will then be imported into the United States. Cold-rolled steel is different from hot-rolled steel in that its production is carried out below recrystallization temperatures, whereas hot-rolling is produced in temperatures above recrystallization. The cold reduction process significantly reduces the thickness of the hot-rolled product and results in a cold-rolled steel possessing greater tensile strength. In fact, the…
Not sure this code fits your product? HaiLang AI determines the US HTS code from a description in about a minute.
Classify a product