Of tool steel (other than high-speed steel): — Other: — Of a width of less than 300 mm
Part of: 722691 — Other: — Not further worked than hot-rolled:
E82976 · 1999-06-17 — The tariff classification and status under the North American Free Trade Agreement (NAFTA), of alloy steel and alloy tool steel plate from Canada; Article 509
, you requested a ruling on the status of alloy steel plate from Canada under the NAFTA. Hot-rolled flat-rolled alloy steel (AISI 4140 and AISI P20 having a carbon content of less than 0.3 percent) and alloy tool steel (AISI A2, AISI D2 and AISI P20 having a carbon content not less than 0.3 percent) plates ranging from 0.5 inch to 16 inches in thickness, from 40 inches to 80 inches in width and from 120 inches to 160 inches in length are produced in various European countries and imported into Canada. These hot-rolled alloy steel and alloy tool steel plates are classified under heading 7225,…
958589 · 1996-02-14 — PRD 1703-95-100104; Chipper Knife Steel, Flat-RolledProducts of Other Alloy Steel, Heading 7226,Chapter 72, Note 1(k), Bars and Rods of Other Alloy Steel, Other, Not Further Worked Than Hot-Rolled, of Tool Steel,Subheading 7228.30.60; Chapter 72,Additional U.S. Note 1(e)(ii); Customs Laboratory Report, Customs Directive 099 3820-002, HQ 950929
This is our decision on Protest 1703-95-100104, filed against your classification of certain alloy steel made in Germany, described as chipper knife steel. The entries under protest were liquidated on May 26, June 2, 9, and 16, and on July 21, 1995. This protest was timely filed on August 14, 1995. FACTS: The steel in issue is invoiced as alloy tool steel, chipper knife steel. This merchandise is further described as being hot rolled, annealed and sandblasted, with saw-cut ends. Dimensions on the submitted invoices range from 57.91 mm x 9.45 mm x 4267 mm to 193.3 mm x 17.28 mm x 4267 mm. The…
950929 · 1992-03-31 — Protest No. 0401-91-000108; Hot-Rolled Steel Sheets; "toolsteel;" Add. U.S. Note 1(e)(iv) to Chapter 72; Consolidated CorkCorp. and Milton Snedeker Corp. v. United States; GRI 3(a); GRI 6
This protest concerns the tariff classification of hot- rolled steel sheets under the Harmonized Tariff Schedule of the United States (HTSUS). FACTS: The entry in question consisted of a shipment of hot-rolled alloyed steel sheets produced from two different heats--heat #31446 and heat #31737. Both were entered under subheading 7226.91.80, HTSUS, which describes other flat-rolled products of alloy steel, of a width of less than 600 mm, not further worked than hot-rolled. A sample from each of the two heats was provided to the New York Customs Laboratory. The laboratory report for heat #31446…
Not sure this code fits your product? HaiLang AI determines the US HTS code from a description in about a minute.
Classify a product