Other: — With a diameter or cross section measuring less than 76 mm
Part of: 72285050 — Other
N326109 · 2022-06-06 — The tariff classification of alloy steel bars from China, Ukraine or Slovenia
The products under consideration are precision ground alloy steel flat bars. Available in Grades A2, S7 and 01 tool steel and Grade 4140 alloy steel, these cut-to-length bars will ultimately be used in the manufacture of tools, dies and molds. According to your submission, the tool steel bars will measure 2 inches (50.8 mm) in thickness whereas the alloy steel bars will have a thickness ranging from 0.0625 inch (1.58 mm) up to and including 2 inches (50.8 mm). You indicate that these bars will be imported in widths ranging from 0.50 inch to 12 inches (12.7 mm to 304.8 mm). Flat-rolled…
N314570 · 2020-09-29 — The tariff classification of various steel bars from China, Ukraine or Slovenia
The products in question are various cold-finished round bars. According to your submission, these bars will be imported in stainless steel grades 440C and 420 ESR and alloy steel grades L6 and Cru501. Although each of these steels are referred to as tool steel in the furnished spec sheets, they do not meet the chemical requirements of a tool steel as defined in Chapter 72, Additional U.S. Note 1(e). You indicate that the stainless steel bars will have a diameter of either 12.70 mm or 101.60 mm, while the alloy bars will measure either 50.80 mm or 101.60 mm. In addition, you state that both…
N182417 · 2011-09-23 — The tariff classification of steel bars from Lichtenstein.
The products to be imported are alloy steel bars made to SAE grade 5117 chemistry. These bars have been hot-rolled, spheroidized annealed and peeled to a diameter of 26.3 mm. Imported in lengths of 117.1 mm, they will be used in the automotive industry. The applicable subheading for the steel bars will be 7228.50.5015, Harmonized Tariff Schedule of the United States (HTSUS), which provides for other bars and rods of other alloy steel; angles, shapes and sections, of other alloy steel; hollow drill bars and rods of alloy or non-alloy steel, other bars and rods, not further worked than…
966169 · 2003-04-08 — Steel Bars with Chamfered Ends for use as Precision Linear Shafts;
We have considered this submission as a request for reconsideration of New York Ruling letter (NY) I85075, dated September 19, 2002. Your letter was forwarded to this office for reply. A sample was provided for our examination. After review of NY I85075, Customs and Border Protection (Customs) has determined that the classification of the chamfered precision linear shafts under subheadings 7215.50.00, 7222.20.00, 7228.50.50, HTSUS, is correct. FACTS: In NY I85075, in response to your classification request, certain nonalloy steel bars of circular cross section were classified under subheading…
I85075 · 2002-09-18 — The tariff classification of steel bars from Germany.
Descriptive literature was submitted with your ruling request. The products to be imported are solid steel bars of circular cross section. You state that the bars may be nonalloy, alloy or stainless steel. Prior to importation, these bars are ground to specific tolerances and are surface hardened through heat treatment. The bars will be imported in material lengths or in cut lengths. The cut-to-length bars may be chamfered on the ends. Although some of the bars may be drilled or drilled and tapped with holes, this ruling will address only those bars that have not been drilled or tapped. These…
Not sure this code fits your product? HaiLang AI determines the US HTS code from a description in about a minute.
Classify a product